FREE SHIPPING ON DOMESTIC ORDERS OVER $75
My Cart

PixelPusher LPD8806 RGB LED Strip, IP65 adhesive backing

$120.00
In stock
SKU
SKU-285
[SKU-285] PixelPusher LPD8806 RGB LED Strip, IP65 adhesive backing

IP65: Protected against water from any angle, this silicone-encapsulated strip has a 3M adhesive backing for permanent installation.

These LED strips are five metres long , just over 15 ft. They can be cut at two LED intervals and rejoined by soldering. There are 48 LEDs per metre- they are about eight tenths of an inch apart. Each pixel is individually controllable.

What are the width's of the strips? IP65 and IP67 are just under 3/4" wide. IP68 is just under 1" wide. The IP65 strip is self-adhesive and will attach to surfaces permanently. IP67 is encased in a continuous high-temperature silicone tube, and IP68 is set in solid silicone.

The strips are flexible but must not be kinked; the minimum bend radius is about three inches.

The strips may be daisychained, but performance suffers. We get much better performance by driving them in parallel. You can daisy chain shorter segments if you want but we recommend a max of 240 pixels on any one controller port. Each controller has eight ports.

More information about the PixelPusher is available at Heroic Robotics