FREE SHIPPING ON DOMESTIC ORDERS OVER $75

Welcome

Lumintop FW21 PRO Copper Flashlight Triple CREE XHP50.2 Cool White

SKU:FW21 Pro COPPER

Availability: Low Stock 7 Remaining

Low Stock 7 Remaining

$109.95

PRODUCT DETAILS

 

PLEASE NOTE: THIS FLASHLIGHT IS NOT A TOY, EXTREME TEMPERATURES CAN CAUSE BURNS, PLEASE EXERCISE CAUTION WHEN LENDING THIS PRODUCT OUT TO OTHER PEOPLE, OR WHEN STORING IT WITH A BATTERY

Toykeeper developed and supports Anduril, the firmware and interface onboard the FW3A. She is also responsible for many of the other firmware and interfaces behind popular BLF projects. Please visit her Patreon and support her hard work!

Specifications:
Emitters: 3 x CREE XHP50.2 
     Cree XHP50.2 (Cool White)

Reflector: Orange Peel
Lens: Glass with AR coating
Max Output: 
     ~10,000 lumens (XHP50.2)
Peak Beam Intensity:
     ~26,055 candela / ~325 meters throw 

The FW21 PRO will thermally throttle based on a preset and programmable maximum temperature (Default 45C, temperature sensor should be calibrated before use, refer to manual below for instructions) for the first 10 seconds it will run unchecked then throttle itself.

Constant reactivation of turbo mode can easily cause the flashlight to EXCEED safe operating temperatures.

Special Modes:
Battery check, sunset, beacon, tactical strobe, party strobe, bike flasher, candlelight, lightning storm

Driver: FET+7+1 driver. Low parasitic drain while OFF
Firmware: The FW21 PRO uses free software called Andúril programmed by ToyKeeper of BLF, distributed under the terms of the GPL v3. The code is available at http://tiny.cc/TKAnduril
Body: Copper
Switch: Electronic tail switch
Ingress rating: Equivalent to IPX8
Battery: One flat-top or button-top high discharge (>10A) unprotected 18650 cell (max length 70.5mm). Battery is NOT included. 
Recommended batteries: 18650: Sanyo GA, Samsung 35E, 21700: Samsung 30T
Weight: ~245g (8.64oz) without battery 
Size: 40mm (1.57") head diameter, 102mm (4.02") length, 28mm (1.09") body diameter

User interfaces and features: 
By default the FW1A is set to use Smooth Ramping for mode changing
Direct access to turbo mode shortcut.
A more conventional Stepped Ramping UI is available if you prefer discrete modes level. (Number of steps is configurable)
Momentary mode useful for signaling purposes or rapidly/briefly lighting up targets. To exit this mode, physically disconnect power
Muggle mode uses reduced output and features
Electronic lockout for safety and low momentary.

ANDURIL QUICK REFERENCE SHEET:

THE PINK HIGHLIGHTED AREA IS THE PATH TO CONFIGURE THE TEMPERATURE SENSOR

MANUFACTURED BY :

Lumintop