FREE SHIPPING ON DOMESTIC ORDERS OVER $75

Welcome

Lumintop FW4A TLF/BLF EDC Aluminum Flashlight

SKU:FW4A

Availability: In Stock

$54.95

PRODUCT DETAILS

18350/18500 BODY TUBES, AND GITD TAILCAP AVAILABLE HERE.

PLEASE NOTE: THIS FLASHLIGHT IS NOT A TOY, EXTREME TEMPERATURES CAN CAUSE BURNS, PLEASE EXERCISE CAUTION WHEN LENDING THIS PRODUCT OUT TO OTHER PEOPLE, OR WHEN STORING IT WITH A BATTERY

Toykeeper developed and supports Anduril, the firmware and interface onboard the FW4A. She is also responsible for many of the other firmware and interfaces behind popular BLF projects. Please visit her Patreon and support her hard work!

Specifications:
Emitters: 4 x LEDS on Copper DTP MCPCB 
     Cree XP-L HI 1A (Cool White 6500K)
     Luminus SST20 (Neutral White 4000K 95 CRI)

Optic: Standard TIR Optic
Max Output: 
     ~3,600 lumens (XP-L HI)
     ~2,100 lumens (SST-20)

Peak Beam Intensity: ~10,180 candela / ~208 meters throw (XP-L Hi)

**The FW4A will thermally throttle based on a preset and programmable maximum temperature (Default 45C, temperature sensor should be calibrated before use, refer to manual below for instructions) for the first 10 seconds it will run unchecked then throttle itself.

Constant reactivation of turbo mode can easily cause the flashlight to EXCEED safe operating temperatures.

Special Modes:
Battery check, sunset, beacon, tactical strobe, party strobe, bike flasher, candlelight, lightning storm

Driver: FET+7+1 driver. Low parasitic drain while OFF
Firmware: The FW3A uses free software called Andúril programmed by ToyKeeper of BLF, distributed under the terms of the GPL v3. The code is available at http://tiny.cc/TKAnduril
Body: Aluminum with hard-coat anodizing
Switch: Electronic tail switch
Ingress rating: Equivalent to IPX7
Battery: One flat-top or button-top high discharge (>10A) unprotected 18650 cell (max length 66mm). Battery is NOT included. 
Recommended batteries: Sanyo GA, Samsung 35E
Weight: ~63g (2.22oz) without battery 
Size: 28.5mm (1.12") head diameter, 92.6mm (3.65") length.

User interfaces and features: 
By default the FW4A is set to use Smooth Ramping for mode changing
Direct access to turbo mode shortcut.
A more conventional Stepped Ramping UI is available if you prefer discrete modes level. (Number of steps is configurable)
Momentary mode useful for signaling purposes or rapidly/briefly lighting up targets. To exit this mode, physically disconnect power
Muggle mode uses reduced output and features
Electronic lockout for safety and low momentary.

BLF FW3A INFORMATION THREAD

ANDURIL QUICK REFERENCE SHEET:

THE PINK HIGHLIGHTED AREA IS THE PATH TO CONFIGURE THE TEMPERATURE SENSOR

MANUFACTURED BY :

Lumintop

* Required Fields

$54.95